Find all the publications that have mentioned EonCoat.
In the oil and gas industry, while traditional corrosion protection has relied mostly on short-lived physically-bonded coverings of substrate surfaces such as tapes, elaborate three-part coating systems (zinc, epoxy, and urethane), and cathodic protection, these merely attempt to lengthen the time before the steel asset inevitably rusts. EonCoat is a…
Roof Recoating Enhances Workplace Safety Many industrial facilities such as petrochemical plants must remain safely, efficiently operational with virtually no downtime, unplanned maintenance, or replacement for decades. To protect equipment from corrosion, traditionally three separate coatings are used, often in a zinc, epoxy, urethane combination. While this is common, it…
Must corrosion eat away at the process industries? It’s obvious that corrosion is a big problem in the process industries. Corroded pipe repair or replacement costs industry more than $7 bil- lion per year, the National Association of Corrosion Engineers estimates. This figure can double when lost revenue, productivity, and…
Eating the Oil Industry from the Inside Out While traditional corrosion protection has relied mostly on short-lived physically bonded coverings of substrate surfaces such as tapes, elaborate three-part coating systems (zinc, epoxy and urethane) and cathodic protection, these merely attempt to lengthen the time before the steel asset inevitably rusts.…
Extend Equipment Life Left unprotected from water, steam, salt, oxygen, and other corrosive elements, structural metals such as steel and aluminum can become rusted, pitted, and unusable in critical equipment buildings, and infrastructure. Yet many industrial facilities must operate with virtually no downtime for planned equipment maintenance or replacement for decades. Click…
One Coat Application In contrast to traditional coatings that require three coats, one coat application and minimal prep for the protective ceramic coating provides facility maintenance managers with significant upfront savings. If the substrate is steel, a brush blast can knock off the loose rust so there is no need…
Chemically bonded phosphate ceramics may give operators “a magic bullet” in the fight against corrosion, according to Tony Collins, chief executive officer of EonCoat. Click here to read the full article
Safety Issues for Industrial Coatings For decades, industrial facilities have measured the effectiveness of a coating by its ability to prevent corrosion, which is its fundamental purpose. With the increasing awareness of the potential problems associated with the use of traditional organic-based coatings and the health risks posed to coating…
Safety first for Industrial Coatings Fortunately, in the past decade coating technology has changed dramatically. A new category of inorganic Chemically Bonded Phosphate Ceramics (CBPCs) has been formulated that emits no VOCs or HAPs during or after application, has no flashpoint, flame spread or hazardous waste disposal requirements. Some of…
One Coat Applications Many industrial facilities, such as petrochemical plants, must remain safely, efficiently operational with virtually no downtime, unplanned maintenance, or replacement for decades. Click here to read the full article